First establish which signal has been lost. A station that disappears from the Console, a station that stays online with poor satellite observations and a rover that stops receiving corrections are three different faults.
Start at the receiver
Write down when the failure began and check the LEDs before restarting. The red power light should be steady. If it is off, begin with the outlet and specified supply. On the MobileCM in the official connection guide, the green light describes the network connection. A slow blink indicates setup mode. Fast blinking means it is attempting the configured Wi-Fi. Alternating short and long flashes mean Wi-Fi is connected but internet access is unavailable. A steady green light indicates an internet connection.
Separate a network failure from a GNSS failure
If you changed router or Wi-Fi credentials, use the MobileCM setup steps to reconnect. If the green indicator is steady, look at the middle orange indicator. A pulse about once per second indicates the receiver sees satellites. Then check the station’s latest observation time and history in the performance dashboard. An old dashboard entry is a different clue from a current entry reporting poor reception.
Compare the failure with the site history
Suppose the station stayed online throughout a day when satellite tracking fell. Check whether scaffolding appeared, the antenna moved or the coax route was disturbed. For this symptom use the low satellite count guide. If you contact support, send the model, time zone, interval affected, LED patterns and a photo of the installation. Keep passwords and the miner key out of screenshots.