Internet requirements for an Anyone hardware relay

Internet requirements for an Anyone hardware relay

For Relay Mode the connection needs to work in both directions. Your device must reach the internet, and the relay must pass Anyone’s inbound reachability test. A fast speed test alone does not establish that other relays can connect.

Check the connection at home

A wired connection makes it easier to separate a Wi-Fi issue from an internet issue. Run Anyone’s reachability and bandwidth self-tests with normal household traffic. If the first test fails, check how the internet provider assigns addresses. Carrier-grade NAT can prevent normal inbound forwarding.

What to tell support

Record whether the device uses Ethernet or Wi-Fi, which self-test fails, and whether the provider supplies a public address. A dynamic public address and a shared carrier address are different problems. Use the documented port for your relay configuration and keep unrelated services closed.

Ask your ISP a precise question

If the relay works locally but fails the official external port check, ask your ISP whether your service uses carrier-grade NAT and whether a publicly reachable IPv4 address is available. Forwarding a port only on your own router cannot change the provider’s upstream address sharing. Once the line is suitable, repeat the same external check and then verify the relay identity and status.