Getting an Anyone Router ready for relay rewards

Getting an Anyone Router ready for relay rewards

Powering up an Anyone Router starts the device. Earning eligibility requires a configured relay that the network can reach. If you simply want to route your own traffic through Anyone, start with the separate Router Mode instructions.

Set up the role you need

For Relay Mode, follow the official hardware setup for your unit. Configure the uplink and the relay identity in the control panel. Run the built-in reachability and bandwidth checks before assuming the device is contributing. A working internet connection on a laptop does not prove the relay is reachable from outside.

Check recognition separately

Look up the relay using the identifier provided by the setup guide. If it is offline, record the status and check the connection first. If it is online but rewards are missing, check the current hardware registration and reward conditions. These are separate checks and have different fixes.

Choose the right item to test

Start with wired Ethernet if available and use the specified 5 V, 3 A supply for the model in the hardware setup guide. Identify the appliance on the local network and open its control panel as the guide describes. Choose Relay Mode to contribute network capacity. Record the relay identifier after configuration so you can recognise your own unit in the network status.

If the control panel works but the relay is unreachable

Opening the panel from a laptop proves the local connection works. An outside connection has a different path through your internet provider and router. Run the project’s reachability check for the relay port. If the test fails, check the home internet requirements and ask the ISP whether the line has reachable public IPv4. Avoid changing several router settings at once.

If the relay is online but rewards are absent

Record when it first appeared online. Compare the displayed identifier with the one registered to your hardware and review the project’s current distribution rules. Reconfiguring a working uplink is unlikely to resolve an account registration issue.