Using GEODNET corrections for repeat tractor passes

Using GEODNET corrections for repeat tractor passes

A tractor with compatible guidance can use RTKsub corrections from GEODNET to return to a stored line. That can help with repeat passes for sowing, hoeing or spraying. Alignment depends on the complete system, including the implement and its offsets.

Before making the first line

Confirm the receiver is RTK-enabled, the display can use the service and the antenna position is entered correctly. Check local coverage and establish a fixed position in open sky. Save the field boundary or guidance line in the project reference used by the machine.

When you return to the field

Compare the tractor and implement position with a known pass or physical mark. If the tractor is on line but the tool runs to one side, inspect implement offsets and steering calibration. Changing the correction subscription will not correct a mismeasured implement.

Separate receiver repeatability from tool position

Save an AB line and mark a point where you can compare tracks. Record the receiver position, implement selection and offsets. Return from the opposite direction, then repeat after restarting the system. If the antenna repeats but the implement leaves a gap on one side, check hitch geometry and offsets. If the receiver itself shifts, revisit the correction connection and line reference.