Check the exact aircraft, RTK module and flight app. A brand name does not establish compatibility. Two versions of an otherwise similar drone may differ in both hardware and support for a custom network RTK service.
Three checks before ordering
Does the aircraft have RTK-capable GNSS? Does the supported controller or ground station accept custom NTRIP credentials? Can that client reach the internet and provide the approximate position required by AUTO? If any answer is unclear, consult the device guide for the exact combination.
Use the matching setup guide
RTKsub lists model-specific instructions for several DJI enterprise and agricultural drones, selected Autel models and an ArduPilot workflow. Start with the model name on the aircraft rather than a product-family nickname. If the configuration differs, give support the aircraft, controller, app and firmware versions.
Check the aircraft you actually own
Read the exact model from the aircraft label, then check which controller and pilot app you use. For a DJI Mavic 3 Enterprise, verify that the RTK module is actually fitted. For a Mavic 3 Multispectral, follow the guide for that aircraft. A setup screenshot from another Mavic can show options your aircraft does not have. The RTKsub drone page is the starting point for the model guides.
Run a compatibility check on the ground
Open the correction-source menu. Confirm that it allows your own caster, port, credentials and mountpoint. Supply internet to the device running the NTRIP client and try the RTKsub pre-flight connection test. If the correction menu is absent, check the module and supported app before buying a subscription. If the menu accepts the credentials but the solution stays float, investigate reception separately.