The NTRIP client receives corrections while you measure. The file you usually export for CAD or GIS contains the resulting survey points. Sending a correction stream to a desktop drawing program will not recreate a field survey.
Configure the field job first
Before collecting points, set the coordinate system, units, antenna height and height model. Record point identifiers and keep quality information where the controller supports it. On a known point, check both position and elevation in the intended reference system.
Test a small export
Export a few points using a format supported by both programs, such as an agreed CSV layout. Check column order, easting and northing, decimal separator, units and height meaning in the destination software. Compare a known point before exporting the complete job.
Run a two-point import test
Export two known points with distinct point IDs, eastings, northings and heights. Note the coordinate reference system, axis order, units and whether heights are ellipsoidal or tied to a vertical datum. Open the file in the receiving CAD or GIS software and compare each value with the originals. A CSV header saying Z alone does not establish the height system.
Read a failed import
If the whole job appears far away, check axis order, units and the assigned coordinate system before remeasuring. If the horizontal position agrees but both heights are shifted, check the vertical transformation. Use the field software guide if values already differ in the controller’s original export.